Skip Navigation Website Accessibility
 


Accuquilt Go! Tulip

AQ Cutting Mat Required: GO! Cutting Mat, 6 in. x 6 in. 2 Pack (15.2 cm x 15.2 cm) Item 55139

How to Die Cut Tulip Shapes:

Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.  

  • Center: Cut and fuse 2" x 4 1/2" rectangles. Cut eight centers across the width of fabric. One yard of 40" wide fabric cuts 144 centers. 
  • Outside Petals: Cut and fuse 3 3/4" x 5 3/4" rectangles. Cut 12 outside petals across the width of fabric. One yard of 40" wide fabric cuts 108 outside petals.

Why Quilters Love the GO! Tulip Die: 

  • The GO! Tulip die cuts two petal shapes and a center to make one gorgeous tulip, providing unlimited options for adding fun flowers to any project from quilt tops to table runners.  
  • No templates required. The GO! Tulip die includes three shapes that are typically difficult to cut by hand. 
  • Mix and match tulips with other GO! floral dies to custom design your own quilted garden. 
  • Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric). 
  • Cut flower shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more! 
  • A great way to use up scraps. 
  • Free pattern downloads available to get you started. 
  • Charm Pack-friendly.

AccuQuilt Benefits: 

  • Cut so much more fabric in less time. 
  • Get accurate cuts every time -- No slipping rulers or mistakes
  • Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
  • Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
  • Safe to use -- No blades come anywhere near your fingers

Die Tips: 

  • With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
  • Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
  • Use good quality fabric to reduce fabric stretch. 
  • It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.