Skip Navigation Website Accessibility
 


Accuquilt Go! Ring of Oak

AQ Cutting Mat Required: GO! Cutting Mat, 5 in. x 10 in. 2 Pack (12.7 cm x 25.4 cm) Item 255110

How to Die Cut Ring of Oak Shapes:

Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.  

  • Oak Leaf: Cut and fuse 3 3/4" squares. Cut 10 oak leaves across the width of fabric. One yard of 40" wide fabric cuts 90 oak leaves. 
  • Curved Square: Cut and fuse 4" squares. Cut 10 curved squares across the width of fabric. One yard of 40" wide fabric cuts 90 curved squares. 
  • Arc: Cut and fuse 2" x 4" rectangles. Cut 10 arcs across the width of fabric. One yard of 40" wide fabric cuts 180 arcs. 
  • Heart: Cut and fuse 2" x 2 3/8" rectangles. Cut 16 hearts across the width of fabric. One yard of 40" wide fabric cuts 288 hearts. 

Why Quilters Love the GO! Ring of Oak Die: 

  • No templates required! The GO! Ring of Oak die includes four applique shapes that are typically difficult to cut by hand. 
  • Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric). 
  • Cut Ring of Oak shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more! 
  • A great way to use up scraps. 
  • Free pattern downloads available to get you started. 
  • Charm Pack-friendly.

AccuQuilt Benefits: 

  • Cut so much more fabric in less time. 
  • Get accurate cuts every time -- No slipping rulers or mistakes
  • Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
  • Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
  • Safe to use -- No blades come anywhere near your fingers

Die Tips: 

  • With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
  • Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
  • Use good quality fabric to reduce fabric stretch. 
  • It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.